Charger SRT-8 V8-6.1L VIN W (2006)
17. Remove nut (5) from end of ball joint stud attaching lower control arm to knuckle.
18. Remove knuckle from vehicle.
19. If hub and bearing needs to be removed, perform the following:
a. Remove dust cap (2). When doing this, avoid damaging internal bore of hub to preserve seal integrity.
b. Remove hub nut (1).
c. Slide hub and bearing off knuckle spindle.
20. If shield needs to be removed from knuckle, remove 3 mounting screws, then shield.
21. If lower control arm ball joint needs to be removed from knuckle.
