Charger SRT-8 V8-6.1L VIN W (2006)
NOTE: Always use a NEW O-ring on the end of the pressure hose.
9. Lubricate NEW O-ring on power steering pump end of pressure hose with clean power steering fluid.
10. 2.7L/3.5L Engines - Install pressure hose (2) to pump (1). Tighten pressure hose tube nut to 47 Nm (35 ft. lbs.) torque.
11. 5.7L/6.1L Engine - Install pressure hose (2) to pump (1). Tighten pressure hose tube nut to 47 Nm (35 ft. lbs.) torque.
12. Install air cleaner housing and inlet tube.
13. Connect battery negative cable (2) to battery post. It is important that this is performed properly.
14. Fill pump reservoir with fluid and perform pump initial operation procedure.
