Charger SRT-8 V8-6.1L VIN W (2006)
4. Insert tension strut (2) ball joint stud downward, into knuckle hole.
5. Completely install NEW nut (3) on ball joint stud attaching tension strut (2) to knuckle (1). Tighten nut by holding ball joint stud with a hex
wrench while turning nut with a wrench. Tighten nut using crow foot wrench on torque wrench to 68 Nm + 90° turn (50 ft. lbs. + 90° turn)
torque.
6. Install tire and wheel assembly. Tighten wheel mounting nuts (3) to 150 Nm (110 ft. lbs.) torque.
7. Lower vehicle.
8. Position vehicle on an alignment rack/drive-on lift.
9. Perform wheel alignment.
CAUTION: If the tension strut engine cradle bolt is a wheel alignment adjustment bolt (lengthwise grooved shaft (2)), be sure to only tighten the
nut. Do not rotate the bolt head (1) or damage to the bushing will occur.
