Charger SRT-8 V8-6.1L VIN W (2006)
CAUTION: In following step, use care not to damage ball joint seal boot while sliding Puller, Special Tool 9360, into place past seal boot.
13. Using Puller (1), Special Tool 9360, separate ball joint stud (2) from lower control arm.
14. Remove nut (5) from end of ball joint stud attaching lower control arm to knuckle.
15. Pry knuckle downward and slide ball joint stud out of lower control arm. Position knuckle outward, away from lower control arm.
16. Slide lower control arm out of engine cradle and remove from vehicle.
INSTALLATION
NOTE: If installing a lower control arm engine cradle bolt that is a wheel alignment adjustment bolt (1) (lengthwise grooved shaft (2)), make sure to
install it in the same position which it was in upon removal. For more details on installation of this special bolt.
