Charger SRT-8 V8-6.1L VIN W (2006)
9. Install thrust bearing and nut (4) on end of Bolt. When installing thrust bearing on Installer, be sure to place hardened side against nut. Place
bearing outer cage against stationary component.
10. While holding Bolt head (1) stationary, rotate Nut (4) (using hand tools) installing sleeve in knuckle. Install sleeve until Nut stops turning. Do not
overtighten Nut.
11. Remove special tool.
12. Install spring link-to-knuckle bolt (2) front-to-rear through knuckle and link, then install nut. While holding bolt head stationary, tighten nut to 138
Nm (102 ft. lbs.) torque.
13. Remove under-hoist utility jack or jack stand from under spring link.
14. Insert end of cable (1) through rear knuckle (3) and install mounting screw (2). Tighten screw to 8 Nm (71 inch lbs.) torque.
15. Install parking brake shoe support over hub and bearing mounting screws and onto face of knuckle.
16. Install shoe actuator lever (1) on end of parking brake cable (2). Make sure actuator lever is positioned with word UP facing outward.
17. Install parking brake shoes as well as all components necessary to access them.
