Charger SRT-8 V8-6.1L VIN W (2006)
19. Insert wheel speed sensor head (3) into mounting hole in rear of knuckle.
20. Install screw (2) fastening sensor head (3) to rear knuckle. Tighten Screw to 11 Nm (97 inch lbs.) torque.
21. Install sensor cable at rear brake rotor shield (1).
22. Lower vehicle.
23. Adjust parking brake shoes as necessary.
24. Position vehicle on alignment rack/drive-on hoist. Raise vehicle as necessary to access mounting bolts.
25. Tighten fasteners at knuckle (vehicle at curb height) as follows:
^
Camber Link (1) - 98 Nm (72 ft. lbs.) torque.
^
Compression Link (5) - 81 Nm (60 ft. lbs.) torque.
^
Stabilizer Link - 61 Nm (45 ft. lbs.) torque.
^
Tension Link (6) - 98 Nm (72 ft. lbs.) torque.
^
Toe Link (3) - 81 Nm (60 ft. lbs.) torque.
26. Perform wheel alignment.
