Charger SRT-8 V8-6.1L VIN W (2006)
3. Install stabilizer bar ends (4) to each stabilizer link (3). Slide link ball joint stem (1) through mounting hole in bar. Loosely install nuts (5) at this
time.
4. Raise stabilizer bar to engine cradle, placing bushings (1) into mounted position.
5. Install bolts (2) securing each stabilizer bar isolator retainer (3) to cradle. Tighten bolts to 60 Nm (44 ft. lbs.) torque.
6. While holding stem from rotating at hex (1) or flat (2) tighten stabilizer link nuts at each end of stabilizer bar (4) to 128 Nm (95 ft. lbs.) torque.
7. Install belly pan.
8. Lower vehicle.
RWD
