Charger SRT-8 V8-6.1L VIN W (2006)
4. On each side of vehicle, install bolts (2) securing stabilizer bar isolator retainer halves (2) to cradle. Tighten bolts (2) to 60 Nm (44 ft. lbs.) torque.
5. On each side of vehicle, install stabilizer bar heat shield (3) over stabilizer bar isolator retainer. Install mounting screws (1).
6. While holding stem from rotating at hex (1) or flat (2) tighten stabilizer link nuts at each end of stabilizer bar (4) to 128 Nm (95 ft. lbs.) torque.
7. Install belly pan.
8. Lower vehicle.
