Charger SRT-8 V8-6.1L VIN W (2006)
12. Remove clamp from lower end of coil spring and shock. Push back spring compressor upper and lower hooks, then remove shock assembly from
spring compressor.
13. Install shock assembly on vehicle.
INSTALLATION
AWD
1. Guide shock assembly up into shock tower (3) and into mounting holes.
2. Install three nuts (2) fastening shock assembly (4) to shock tower (3). Tighten nuts to 27 Nm (20 ft. lbs.) torque.
3. If equipped, align shock tower cap (1) with shock mounting nuts (2) and snap into place.
4. Raise and support vehicle.
5. Pull lower end of shock assembly outward, then slide clevis bracket (3) onto lower end. Slide clevis bracket onto shock assembly until bracket
contacts collar on shock housing (2).
6. Install pinch bolt and nut (1) fastening clevis bracket (3) to bottom of shock assembly (2). Install pinch bolt from rear. Do not tighten at this time.
