Charger SRT-8 V8-6.1L VIN W (2006)
Seals and Gaskets: Service and Repair
Seal - Pinion Flange
SEAL - PINION FLANGE
REMOVAL
1. Remove rear axle assembly from vehicle.
2. Measure axle assembly rotating torque and record measurement for reuse on assembly.
3. Using flange holder C-3281(1) and 41mm socket, remove pinion flange nut and discard.
NOTE: Due to axle imbalance concerns, it is necessary to make sure pinion flange-to-shaft orientation is maintained. If alignment marks are not