Charger SRT-8 V8-6.1L VIN W (2006)
visible, apply appropriate marks before removing pinion flange.
4. Using puller 1026 (1), remove pinion flange (2) from pinion shaft.
5. Using suitable tool (1), remove pinion seal (2) and discard.
INSTALLATION
1. Apply light coating of gear lubricant to the lip of the pinion seal.
2. Using Tool 9754 (1), install pinion seal until tool bottoms on carrier.
3. Install pinion flange into position. Align index marks to maintain assembly balance.
4. Using Installer 6448A (1), lightly tap on pinion flange (2) until adequate pinion shaft threads are exposed.
