Charger SRT-8 V8-6.1L VIN W (2006)
CAUTION: Unequal-length halfshafts are used. The left halfshaft is shorter than the right, and it is necessary to identify and tag halfshafts upon
removal to ensure proper installation.
14. Lower axle just enough to remove halfshafts one at a time. Shift axle assembly in one direction, compressing one halfshaft while removing the
other (1). Use caution to protect axle seal and journal.
CAUTION: Never grasp halfshaft assembly by the inner or outer boots. Doing so may cause the boot to pucker or crease, reducing the service
life of the boot and joint. Avoid over angulating or stroking the C/V joints when handling the halfshaft.
CAUTION: Use care while handling/storing halfshaft assembly. Damage to the slinger can result from improper handling. If slinger gets bent or
damaged, straighten slinger to avoid contact with axle seal assembly.
15. Remove halfshaft from hub. Remove and inspect rubber isolation washer (1). Discard washer if rubber surfaces are worn away. Repeat on other
side if necessary.
