Charger SRT-8 V8-6.1L VIN W (2006)
Back Window Glass: Service and Repair
BACKLITE
REMOVAL
NOTE: Windshield removal shown, backlite similar.
1. Before proceeding with the following repair procedure, review all warnings and cautions. Refer to Windows and Glass / Service Precautions.
2. Remove quarter trim panels Refer to Trim Panel.
3. Remove the trim panel from the rear shelf Refer to Trim Panel.
4. Disconnect the wire connectors from rear window defogger terminals and, rear window mounted radio antenna, if equipped.
CAUTION: Be careful not to damage painted surfaces when cutting urethane around the backlight.
5. Using an assistant and a wire-type windshield cutout tool (1, 3 and 4), cut and separate the urethane adhesive (2) securing the backlite to the
backlite fence.
6. Carefully remove the backlite from the vehicle.
INSTALLATION
CAUTION:
-
To help prevent water leaks, partially roll down the left and right door glass before installing the backlite. This avoids pressurizing
the passenger compartment if a door is slammed before the urethane is cured.
-
Protect all painted and trimmed surfaces from coming in contact with urethane or primers.
1. If the backlite (1) is being reused, remove the as much original urethane (3) as possible from the glass surface using a razor knife (2).
