Charger SRT-8 V8-6.1L VIN W (2006)
NOTE:
-
To prevent corrosion, do not damage paint on the backlite fence when removing original urethane.
-
The backlite fence should be cleaned of most of its old urethane adhesive. A small amount of old urethane, approximately 1 mm in height
should remain on the fence. Do not completely remove all old urethane from the fence, the paint finish and bonding strength will be adversely
affected. Replace any missing or damaged spacers around the perimeter of the backlite fence.
2. Using a razor knife (2), level the original bead of urethane (1) on the backlite fence (3) to a thickness of approximately 1 mm (0.04 in.) and
remove the loose adhesive.
3. Install a new rubber seal (1) around the top and side edges of backlite (2).
4. Using an assistant, position the backlite into the backlite opening and against the backlite fence (3).
5. Verify the backlite lays evenly against the fence at the top, bottom and sides of the opening. If not, the fence must be formed to the shape of the
backlite.
6. Mark the backlite and fence with a grease pencil or pieces of masking tape to use as a reference for installation.
7. Using an assistant, remove the backlite from the backlite opening and place it on a suitable padded work surface.
