Charger SRT-8 V8-6.1L VIN W (2006)
Quarter Window Glass: Service and Repair
GLASS-QUARTER
REMOVAL
1. Before proceeding with the following repair procedure, review all warnings and cautions Refer to Windows and Glass / Service Precautions.
2. Remove the quarter panel trim from the side of the vehicle being serviced Refer to Trim Panel.
3. Carefully pull down the headliner to access the upper mounting studs (1) that secure the quarter glass (2) to the window fence (3) and, remove the
nuts from the studs.
4. Remove the nuts that secure the lower mounting studs (4) to the window fence and, remove the nuts from the studs.
5. Using razor knife, cut butyl sealer between the mounting studs that secure the quarter glass to window fence.
6. Carefully push the quarter window glass from the opening.
INSTALLATION
CAUTION: Roll down the left and right front door glass and open the liftgate glass before installing quarter glass to avoid pressurizing the
passenger compartment if a door is slammed before urethane is cured. Water leaks can result.
NOTE: The quarter glass fence should be cleaned of all old butyl sealer. Do not grind sealer off the fence, the paint finish will be adversely affected.
1. Apply 6 mm (0.25 in.) wide butyl tape around perimeter of the (2) quarter glass approximately 5 mm (0.2 in.) from the edge of the glass. Ensure
the butyl tape is wrapped around the mounting studs.
2. Place the quarter glass into the window opening (3) and insert mounting studs (1 and 4) through the holes in the window fence.
3. Install the nuts that secure the quarter glass to the window fence. Tighten the nuts to 4.5 N.m (40 in.lbs.).
4. Install the headliner.
5. Install quarter panel trim.