Colt L4-089 1468cc 1.5L VIN K 2-bbl (1988)
Throttle Position Sensor Location
6.
If the output voltage is not correct, loosen the TPS mounting screws and turn the TPS body to adjust to specification.
NOTE: Turning the TPS body clockwise increases the output voltage.
7.
Turn the ignition switch to OFF.
8.
Tighten SAS 1 and SAS 2 by the same number of turns as loosened in step (2) to return them to initial state.
9.
Adjust free play of the accelerator cable. Turn the accelerator adjusting nut to the point where the throttle lever just starts moving, then back off
one turn and secure the lock nut.
10.
Start the engine and check that the idle speed is at 700 rpm for manual transaxles in NEUTRAL, and at 750 rpm for automatic transaxles in
PARK.
