Colt L4-1410cc 1.4L SOHC (1984)
This procedure requires the use of a volt-ohm meter capable of reading D.C. voltages of up to 15 volts and resistances up to 1000 ohms, a vacuum source
such as a hand SPC test pump, a few feet of 5/32" vacuum hose, and several jumper wires.
1.
CONTROL SWITCH TEST
A.
First, test pin #9 (yellow wire) for ignition voltage (12V).
B.
Remove the cruise control module from its mounting position such that it is accessible and still connected to its wiring harness. In this test the
