Colt L4-1410cc 1.4L SOHC (1984)
Fig. 15 Installing bushing ``A'' into left suspension arm. Colt & Colt Vista w/2 wheel drive
2. Apply grease to outer surfaces of bushings, then using tools Nos. MB990779 and MB990780, drive bushing B in until tool contacts end of left
suspension arm. Using tool No. MB990780, drive bushing A into left suspension arm.
3. Position dust cover on right suspension arm, then coat suspension arm with grease from shoulder at mounting bracket end approximately 15.7
inches toward center of arm and install rubber stopper.
4. On models equipped, align stabilizer bar and stabilizer bar bracket marks.
5. Carefully push left and right suspension arms together, while wiping excess grease as necessary, then align suspension arm and component
alignment marks.
Fig. 16 Installing mounting bracket components. Colt & Colt Vista w/2 wheel drive
6. Install washers and mounting brackets as shown. Loosely install mounting bracket nuts. Do not tighten nuts until suspension assembly has been
installed and vehicle lowered to floor.
7. Pack dust cover with grease, then install cover retaining clamp.
INSTALLATION
1. Position suspension arm assembly to body, then install mounting bracket to body attaching bolts. Torque attaching bolts to 36-51 ft. lbs.
2. Install coil spring assembly.
3. Lower vehicle, then torque mounting bracket to suspension arm attaching nuts to 47-54 ft. lbs.
