Colt L4-1597cc 1.6L SOHC Turbo (1984)
Paint: Technical Service Bulletins
Synthetic Resin Bumpers - Painting
Models
All 1984 & 1985 Imports
Subject
Painting of Synthetic
-
Resin Bumpers
Index
BODY
Date
November 18, 1984
No..
23-21-84
P-5119-C
Service replacement bumpers available through Parts Supply are finished in a neutral (off white) shade. Proper preparation of these synthetic-resin
(polyurethane and polypropylene) bumpers prior to painting is necessary.
NOTE:
PLEASE ASSURE THAT YOUR BODY SHOP FOREMAN AND/OR PAINTER HAS THIS INFORMATION.
REFINISHING PROCEDURES
1.
Attach bumper to bumper core or support.
2.
Mask all areas which are not to be painted.
3.
Carefully water sand entire bumper area which is to be painted, using #400 or #600 water resistant sandpaper.
DO NOT REMOVE OFF WHITE PAINTED SURFACE FROM BUMPER.
4.
Degrease surface with wax and grease remover.
5.
Spray color coat onto bumper following paint manufacturer's instructions.
6.
Allow color coat to dry naturally (at room temperature) for approximately ten minutes, if clear coat is to be used.
CAUTION: DO NOT ALLOW DUST OR OTHER FOREIGN MATTER TO ADHERE TO PAINTED SURFACE.
7.
Spray clear coat onto bumper following paint manufacturer's instructions.
NOTE:
STEPS (6) AND (7) ARE ONLY USED FOR PAINT COATS WITH METALLIC FINISH.
8.
Allow paint to dry.
CAUTION: IF PAINT IS GOING TO BE QUICK DRIED (OVEN OR HEAT LAMP), FIRST ALLOW IT TO AIR DRY FOR
APPROXIMATELY 15 MINUTES.
POLICY:
Information only