Colt L4-1597cc 1.6L SOHC Turbo (1984)
Ignition Ballast Resistor: Testing and Inspection
Fig. 19 ECI resistor
Fig. 20 Measuring resistor values
1984-86 Models
1.
Disconnect harness connector at resistor located near ignition coil, Fig. 19.
2.
Measure resistance across terminals 1 and 2, then 1 and 3. Resistance should read approximately as shown, Fig. 20. If resistor reads 0 ohms or
infinity, replace resistor.
3.
Install resistor, then firmly connect connector.
