Colt L4-1795cc 1.8L SOHC (1994)
Basic Idle Speed Adjustment
7. If not within the standard value range, turn the engine speed adjusting screw (SAS) to make the necessary adjustment.
NOTE: If the idling speed is higher than the standard value range even when the engine speed adjusting screw is fully closed, check whether
or not there is any indication that the fixed SAS has been moved. If there is an indication that it has been moved, adjust the fixed SAS. If there
are no indications that it has been moved, it is possible that there is leakage as a result of deterioration of the fast idle air valve (FIAV), and, if
so the throttle body should be replaced.
8. Switch OFF the ignition switch.
9. If the scan tool was not used, disconnect the jumper wire from the diagnostic test mode control terminals.
10. Disconnect the jumper wire from the ignition timing adjustment terminal and return the connector to its original condition.
11. Start the engine again and let it run at idle speed for about ten minutes; check to be sure that the idling condition is normal
