Colt L4-1795cc 1.8L SOHC (1994)
Throttle Full Close Switch: Adjustments
NOTE: When using scan tool, proceed to service data item 26 and observe the ON/OFF changes to the closed throttle position switch, instead of
performing ohmmeter tests. If scan tool not available, follow the steps below.
TPS Connector
1. Disconnect the connector of the throttle position sensor.
Adjusting TPS
2. Connect an ohmmeter between terminal 3 (closed throttle position switch) and 4 (sensor ground) by using jumper wires.
Adjusting TPS
3. Insert a feeler gauge with a thickness of 0.65 mm (.0256 in.) between the fixed SAS and the throttle lever.
Adjusting TPS
4. Loosen the throttle position sensor mounting bolt; then turn the throttle position sensor body fully counterclockwise.
