Colt L4-1795cc 1.8L SOHC (1994)
STEERING WHEEL REMOVAL
Remove the steering wheel by using a special tool.
Caution: Do not hammer on the steering wheel. Doing so may damage the collapsible column mechanism.
INSTALLATION SERVICE POINTS
PRE-INSTALLATION INSPECTION
1. When installing the new air bag module and clock spring.
See: Air Bag/Testing and Inspection
Caution: Dispose of an air bag module only according to the specified procedure. See: Air Bag/Service and Repair/Air Bag Module
Disposal Procedures
2. Connect the scan tool to the data link connector.
Caution: Make certain that the ignition switch is at OFF when the scan tool is connected or disconnected.
3. Reconnect negative terminal of battery, and turn the ignition key to the "ON" position.
4. Conduct on-board diagnostic using scan tool to ensure entire SRS operates properly, except open circuit of air bag module (diagnostic trouble
code No.22). See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code
Descriptions/Detailed Descriptions/Restraint Systems/Trouble Code Descriptions/Code 22 Air Bag Module (Squib) System
5. Turn the ignition key to the "LOCK" position, disconnect the negative battery cable and tape the terminal.
Caution: Wait at least 60 seconds after disconnecting the battery cable before doing any further work. See: Service Precautions
