Colt L4-1795cc 1.8L SOHC (1994)
Assemble
A special grease is used to lubricate the drive axle tripod joint and Rzeppa joint. This grease is included in the drive axle repair kit and must be used.
1. Press fit center bearing into center bearing support, then lubricate and press fit dust seals into center bearing.
2. Press fit inner shaft into center bearing, then the inner shaft assembly into Tripod case.
3. Apply grease to drive axle, then install boots.
4. Position tripod joint spider on drive axle, then install snap ring.
5. Apply 2.8-3.2 ounces of special grease to tripod joint housing, then insert drive axle and spider into housing.
6. Apply another 2.8-3.2 ounces of special grease to tripod joint boot.
7. Apply as much special grease as removed to Rzeppa joint, if necessary.
8. Install bands and boots for each joint. When installing boot bands for tripod joint, bands must be positioned 3.1 inches apart (dimension A).
Fig.7 Double Offset Joint Or Tripod Joint Boot Length Measurement
