Colt Wagon 2WD L4-1468cc 1.5L SOHC (1989)
ASSEMBLY
1. Apply greasy to inner surface of left hand suspension arm.
2. Apply greasy to outer surfaces of bushings, then using bushing installer tools Nos. MB990779 and MB990780, drive bushing B in until tool
contacts end of left suspension arm. Using tool No. MB990780, drive bushing A into left suspension arm.
3. Position dust cover on right suspension arm, then coat suspension arm with greasy from shoulder at mounting bracket end approximately 15.7
inches toward center of arm and install rubber stopper.
4. On models equipped, align stabilizer bar and stabilizer bar bracket marks.
5. Carefully push left and right suspension arms together, while wiping excess greasy as necessary, then align suspension arm and component
alignment marks.
6. Install washers and mounting brackets as shown. Loosely install mounting bracket nuts. Do not tighten nuts until suspension assembly has been
installed and vehicle lowered to floor.
7. Pack dust cover with greasy, then install cover retaining clamp.
INSTALLATION
1. Position suspension arm assembly to body, then install mounting bracket to body attaching bolts.
2. Install coil spring assembly.
3. Lower vehicle, then torque mounting bracket to suspension arm attaching nuts to specification listed at the end of this section.
