Colt Wagon 2WD L4-1468cc 1.5L SOHC (1989)
Suspension Spring ( Coil / Leaf ): Service and Repair
Fig. 12 Coil Spring Rear Suspension. 2WD
2WD MODELS
1. Raise and support vehicle, then remove wheel and tire assembly and rear drum brake assembly.
2. Remove brake tube. Disconnect brake hose from torsion axle and arm assembly.
3. Position a piece of wood between a suitable jack and the torsion axle and arm assembly. Do not apply jack to lateral rod. After raising torsion axle
and arm slightly, remove lateral rod from body.
4. Remove torsion axle and arm from body.
5. Disconnect shock absorber upper and lower mounts, then remove shock absorber from vehicle.
6. Remove coil spring and upper spring seat. Note location of spring seats.
7. Reverse procedure to install. Note the following:
a. Coil springs have colored identification marks which indicate specific application. When replacing springs, ensure that replacement springs are
appropriately marked.
b. After completing installation, bleed brake system and adjust rear wheel bearings.
