Conquest TSI L4-2555cc 2.6L SOHC Turbo (1986)
NOTE:
CUT THE ALLEN WRENCH (WITH A WIDTH ACROSS THE FLATS OF 5 mm) TO THE DIMENSION SHOWN
IN THE ILLUSTRATION (FIGURE 2).
d.
Remove the air spoiler from the hatch garnish with a sharp knife to cut the adhesive. (Use care so paint on hatch garnish is not damaged.)
e.
Clean remaining adhesive from liftgate garnish.
FIGURE 3
Installation
Install the new air spoiler in the reverse order of the removal procedure.
2.
Rear Air Spoiler - Side
Removal
a.
Remove the rear seat cushion.
^
Remove the mounting bolts (Figure 3 - Item 1).
FIGURE 4
^
Lift up the seat cushion and pull the rear seat belts through the hole in the cushion (Figure 4).
FIGURE 5