Conquest TSI L4-2555cc 2.6L SOHC Turbo (1986)
h. Install DOJ boot and secure large end with boot band. Measuring from large boot band, install small boot band 3.1 inches down axle shaft.
i.
Pack 3.5-5.3 oz. of repair kit grease into BJ boot, then install boot with boot bands.
j.
Wipe off excess grease.
7. On Colt Vista models, proceed as follows:
a. Fill inside of BJ and BJ boot with 3.2-3.3 oz. of repair kit grease, then install BJ boot with boot bands.
b. Apply repair kit grease to DOJ assembly, then install DOJ onto axle shaft and secure with snap ring.
c. Apply repair kit grease to DOJ outer race, then install axle shaft into DOJ and apply more grease. The amount of grease recommended for
this operation is 2.3-3.3 oz.
d. Install axle shaft circlip.
e. Install DOJ boot and secure large end with boot band. Measuring from large boot band, install small boot band 3.1 inches down axle shaft.
f.
Wipe off excess grease.
INSTALLATION
1. Install dust cover and new circlip on BJ side of axle shaft.
2. Install axle shaft to differential carrier and companion flange.
3. Insert companion flange to axle shaft boots from companion flange side, then install nuts and torque to 36-43 ft. lbs.
