D250 3/4 Ton Pickup 2WD V8-318 5.2L VIN Y FI (1988)
e.
Remove hazard warning switch knob attaching screw, then the turn signal switch attaching screws.
6.
On tilt columns, position steering wheel in midpoint position.
7.
On models equipped with column shift, place selector lever in first or third gear position.
8.
On all models, remove wire cover attaching clips, then the cover if equipped.
Taping turn signal connector and wires
9.
Disconnect turn signal electrical connector. Wrap a piece of tape around the connector and wire to prevent snagging during switch removal.
10.
Remove turn signal/hazard warning switch assembly by pulling switch up from column while straightening and guiding wires up through column
opening.
11.
Reverse procedure to install.
