D50/Power Ram 50 L4-2300cc 2.3L DSL (1984)
Ball Stud: Service and Repair
Fig. 1 Front suspension exploded view
1. Raise and support front of vehicle, and place suitable jack under lower control arm to relieve spring tension from knuckle.
2. Remove hub assembly as outlined, then remove brake rotor dust cover.
3. Remove cotter pin and retaining nut, then disconnect tie rod from knuckle using suitable puller.
4. Remove cotter pins and nuts, disconnect upper and lower ball joints, then remove knuckle.
5. Reverse procedure to install.
