D50/Power Ram 50 L4-2350cc 2.4L SOHC (1992)
camshaft sprocket in that order.
5. Loosen tensioner mounting bolt. By so doing, tensioner will be moved by spring and will apply tension to belt. Remove screwdriver from plug
hole at left side of cylinder block and install plug.
6. Turn the crankshaft in normal direction (clockwise) by two teeth of the camshaft sprocket.
CAUTION: As the purpose of this procedure is to apply the proper amount of tension on the timing belt, be sure not to rotate the crank shaft
counterclockwise or place pressure on the belt to check the amount of tension.
7. Putting pressure clockwise on the tensioner (in the direction of the arrow) such that no portion of the belt raises out in portion A, place the belt on
the camshaft sprocket such that the belt sprocket teeth are fully engaged.
8. Tighten the tensioner bolt and tensioner spacer, in that order.
CAUTION: If the tensioner spacer is tightened first, the tensioner will rotate with it and belt tension be thrown out of adjustment. Always tighten the
bolt first.
