D50/Power Ram 50 L4-2350cc 2.4L SOHC (1992)
Crank Angle And #1 TDC Sensor Location
6. Lightly clamp the distributor in a vise equipped with soft jaws.
7. Pull off the rotor from the rotor shaft.
8. Remove the packing rubber.
9. Lift off the cover.
Rotor Shaft Retaining Screw Location Add
10. Remove the disc and spacer. Observe which side of the disc is the top, for future reassembly.
11. Disconnect the lead wire connector.
12. Lift off the plate and unit by removing the three mounting screws.
13. Remove the shaft bearing tightening screws.
14. Make a position identification mark on the distributor shaft (for the drive gear, to prevent 180° out of alignment, reassembly).
15. Place the drive gear on a soft base (wooden block) so that it will not be damaged.
