D50/Power Ram 50 L4-2350cc 2.4L SOHC (1992)
b.
Fully screw lever onto lever screw, then install lever into lever bolt. Tilt lever is threaded in opposite direction.
c.
Ensure end of lever screw touches bracket stopper plate before attaching tilt lever.
d.
Ensure tilt steering is secured (locked) and free (unlocked) in position shown. If tilt steering is not operating properly, adjust position of tilt
lever screw end which touches stopper plate.
4WD
1.
Inspect joint assembly, steering shaft and tilt bracket for damage and deformation.
2.
Inspect the steering shaft bearing and joint bearing for damage and wear.
3.
Inspect steering shaft joint for play or faulty operation.
2WD
1.
Inspect the steering shaft and tilt bracket for damage and deformation.
2.
Inspect the steering coupling and horn ground spring for damage and deterioration.
3.
Inspect dash panel cover, steering shaft bearing and dust seal for damage and wear.
Service Note
The steering column has been designed to be serviced as an assembly. Most of the removable steering column components may be serviced without
removing the column from the vehicle. For steering column replacement procedure refer to Removal/Installation.
