D50/Power Ram 50 L4-2350cc 2.4L SOHC (1992)
19.
Install bearing on steering shaft. Do not hammer shaft into the bearing or bearing onto shaft as damage to steering column or shaft may
result.
20.
Install upper snap ring on shaft, then install and torque the three bearing housing to lock housing screws to 35 inch lbs.
21.
Install wiring trough in place over wires, being careful not to pinch wires between trough and jacket.
Inspection
1.
Clean all parts in suitable solvent then inspect for wear or damage.
2.
Inspect condition of shift lever gate and inner end of shift lever.
3.
Inspect turn signal switch for distortion, broken or damaged parts.
4.
Inspect steering shaft bearings for smooth operation. Replace bearing if it is rough or worn.
Service Note
The steering column is designed to be serviced as an assembly. Only electrical switches may be serviced, refer to BODY ELECTRICAL SAFETY
AND ENTERTAINMENT for switch replacement procedures. For steering column replacement procedure refer to Removal/Installation.
