dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Radio - Poor Reception/Static/Noise|Page 1890 > < Seat Belt Warning Relay|Locations
Page 1
background image

Antenna: Customer Interest
Radio - Poor Reception/Static/Noise

Models

1987 Ram 50 Pick-Up Trucks

Subject

Radio Antenna Cable Failures

Index

ELECTRICAL

Date

February 16, 1987

No.

08-07-87 C3-08 P-479
This repair applies only to Ram 50 trucks built prior to October 21, 1986.

SYMPTOM/CONDITION

Poor radio reception, intermittent reception, static, or noise from radio.

DIAGNOSIS

1.

Using a circuit tester, check for continuity between antenna mast and body.. Continuity indicates an antenna core cable and shield wire are shorted
and must be replaced.

2.

Plug in a known good antenna to verify condition and, if corrected, replace antenna cable.

PARTS REQUIRED

1

Antenna Base and Cable Assembly

PN MB415352

REPAIR PROCEDURE

Following service manual procedures, replace the antenna cable noting the following differences.

FIGURE 1

1.

The original antenna was held in place by several clips on the floor pan, and was installed directly on the floor pan underneath the silencer pad as
shown in Figure 1.

Radio - Poor Reception/Static/Noise|Page 1890 > < Seat Belt Warning Relay|Locations