D50/Power Ram 50 V6-181 3.0L SOHC (1991)
Installation
1. Tighten the slotted nut by the following procedure: Tighten to 30 Nm (22 ft.lbs.), loosen to 0 Nm (0 ft.Ibs.), retighten to 8 Nm (6 ft.lbs.)
2. Install the cotter pin. If the knuckle spindle hole and slotted nut groove are not in alignment, back off the slotted nut 30° maximum.
3. Apply a semi-drying sealant to the hub cap at portion shown in illustration and install.
