D50/Power Ram 50 V6-2972cc 3.0L SOHC (1990)
DISC:
1.
Install the spacer on the distributor shaft.
2.
Insert the disc into the sensor part of the pick up unit assembly insuring proper alignment with the notch on the spacer.
NOTE: Take care to install the disc with the correct side to the top as was observed during disassembly. Insure that the disc is clean and that the
disc's slits are clear of any foreign matter.
3.
Install the rotor shaft and its retaining screw.
COVER:
Install the cover with the two retaining screws.
