D50/Ram 50 L4-1997cc 2.0L SOHC (1984)
Fig. 22 Assembling rocker arms & rocker arm shafts. 2000cc engine
3.
Apply engine oil to I.D. of rocker arms prior to assembly. Assemble rocker arms, springs and remaining bearing caps on rocker shafts, Fig. 22, in
positions noted during disassembly.
Fig. 23 Hydraulic lash adjuster & retaining clip installation. 1985-88 2000cc & 2600cc engines
4.
On models with hydraulic lash adjusters, insert each adjuster into rocker arm taking care not to spill fluid from adjuster. Retain adjusters using
suitable clips, Fig. 23, to prevent them from falling out during installation.
5.
On all models, install assembly onto cylinder head and evenly tighten bolts in crossing pattern until bearing caps are seated. When caps are seated,
torque bolts to specifications in crossing pattern.
6.
Install sleeve over camshaft and press oil seal into place using suitable driver.
7.
Install camshaft sprocket and timing belt, then ensure timing marks are properly aligned.
8.
Adjust valves to specifications as outlined, then temporarily install rocker cover.
9.
Reverse remaining procedure to complete installation, then check timing belt tension as outlined. After engine reaches normal operating
temperature, recheck valve clearances and adjust as needed.
Fig. 24 Applying sealant to semi-circular packing
10.
When installing rocker cover after checking valve clearances, apply suitable sealer to semi-circular packing and cylinder head, Fig. 24, then install
rocker cover.
