D 100 Pickup L6-225 3.7L (1984)
FIGURE 5
6.
Locate the rectangular shaped reservoir mounting template above and left, 1" off center, of the 1-1/4" clutch actuation cylinder hole that was just
drilled (Figure 4). Make sure the template is pressed down flush with the bulkhead contour and sits snug on the hem flange (Figure 5). Center
punch the three hole locations and drill holes with a 1/4" drill.
7.
Install the reservoir bracket, using the three self-tapping screws provided. Torque screws to 95 inch pounds.
8.
Locate and install the reinforcement plate on the inside of the bulkhead. Mark and drill the two 1/4" mounting holes. Install the bracket and
torque the screws to 200 inch pounds.
9.
Place a bead of silicone sealer around the actuating cylinder mounting holes and install the bracket. Torque the retaining nuts to 200 inch
pounds.
FIGURE 6
