D 150 Pickup V6-239 3.9L (1992)
Ignition Hall Effect Sensor: Service and Repair
NOTE:
Distributor removal is not necessary to the pick-up assembly.
REMOVAL
1.
Remove distributor cap from distributor (two screws).
2.
Disconnect pick-up harness from main engine wiring harness.
3.
Remove distributor rotor from distributor shaft.
Distributor (Hall Effect) Pick-up
4.
Lift the pick-up assembly from the distributor housing.
INSTALLATION
1.
Install the pick-up to the distributor. Align the pick-up into the notch on the distributor.
2.
Connect wiring harness.
3.
Install rotor.
4.
Install distributor cap.