D 250 Pickup V8-360 5.9L VIN W (1987)
FIGURE 1-A - ENGINE COMPARTMENT WIRING
3.
Route and secure the engine overlay harness, PN 4362295, along the existing headlamp-to-dash main engine wiring harness from the ignition
coil to the bulkhead connector, using the existing wiring clips and four tie wraps, PN 6015756.
Loop and tape excess wire of the overlay harness - Figure 1-A.
FIGURE 1-B
4.
Install the bare eyelet terminal of the overlay harness to the negative terminal of the ignition coil as shown in Figure 1-B.
