D 250 Pickup V8-360 5.9L VIN W (1987)
FIGURE 2-C - INSTRUMENT PANEL WIRING
B.
Instrument Panel Harness PN 4362284
1.
Insert the two bare terminals from the instrument panel overlay harness, PN 4362284, into insulator located on the instrument panel side of
jumper wiring assembly, PN 4362558, per Figures 2-C and 5.
NOTE:
DISCONNECT MALE INSULATOR FROM FEMALE INSULATOR PRIOR TO INSERTION OF TERMINALS, AND BE
SURE WIRES OF INSTRUMENT PANEL HARNESS MATE WITH SAME COLOR WIRES OF JUMPER, RECONNECT
INSULATORS.
FIGURE 2-B - TERMINAL END OF IGNITION SWITCH CONN. (PART OF INSTRUMENT PANEL WIRING)
2.
Disconnect the arced grey 7-way ignition switch connectors and remove the yellow wire from the instrument panel side (Figure 2-B). Install the
yellow wire just removed, into the natural colored 1-way connector supplied with the instrument panel overlay harness, PN 4362284.
FIGURE 2-B - TERMINAL END OF IGNITION SWITCH CONN. (PART OF INSTRUMENT PANEL WIRING)
