dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Speed Control - Surge at highway Speeds|Page 2539 > < Speed Control - Surge at highway Speeds|Page 2533
Page 1
background image

Speedometer Gear, A/T: All Technical Service Bulletins
Speed Control - Surge at highway Speeds

NO.: 
08-07-93 Rev. A

GROUP:
Electrical

DATE:
Mar. 19, 1993

SUBJECT:
Speed Control Surge

NOTE:
THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 08-07-93 WHICH SHOULD BE REMOVED FROM YOUR FILES. ALL
REVISIONS ARE HIGHLIGHTED WITH **ASTERISKS**.

NOTE:
THIS BULLETIN APPLIES ONLY TO FOUR WHEEL DRIVE VEHICLES EQUIPPED WITH THE CUMMINS DIESEL ENGINE.

MODELS:

1992-93 (AD) Ram Pickup/Ram Cab Chassis

SYMPTOM/CONDITION:

Some vehicles may exhibit a speed variation at highway speeds while the speed control is engaged.

DIAGNOSIS:

1.

Perform the speed control system test as outlined in Section 8H of the service manual. If no problems are found during the test, proceed to step 2.

2.

On 1992 vehicles verify that the vehicle is equipped with the correct speed control servo and cable for the Powertrain Control Module (SBEC) that
is installed, Refer to the chart below and make sure that the Powertrain Control Module, servo and cable match.

POWERTRAIN CONTROL MODULE REFERENCE CHART

SBEC Part No.

Servo Part No.

Cable Part No.

56027570

53007954 (Zemco)

**4428787**

56027571

53007954 (Zemco)

**4428787**

56027572

53007954 (Zemco)

**4428787**

96027573

53007954 (Zemco)

**4428787**

POWERTRAIN CONTROL MODULE REFERENCE CHART CONT'D

SBEC Part No.

Servo Part No.

Cable Part No.

56027081

53009315 (Eaton)

**52078330**

56028082

53009315 (Eaton)

**52078330**

56027083

53009315 (Eaton)

**52078330**

56027084

53009315 (Eaton)

**52078330**

3.

If no problems have been found to this point, the speedometer drive gear on the output shaft of the NP 205 transfer case may be at fault. Remove
the speed sensor, adapter and the speedometer drive gear. Carefully inspect the speedometer drive gear while rotating the output shaft. Any cuts or
irregularities on the gear can cause a speed sensor signal variation. If any irregularities are present, proceed to the repair procedure.

PARTS REQUIRED:

1

Speedometer Drive Gear

3732038

REPAIR PROCEDURE:

Replace the speedometer drive gear using the procedures outlined in Section 21 of the Rear Wheel Drive Dodge Truck Service Manual.

Speed Control - Surge at highway Speeds|Page 2539 > < Speed Control - Surge at highway Speeds|Page 2533