D 250 Pickup V8-5.9L VIN Z (1992)
Fig. 54 Reverse idler shaft installation
7.
Install reverse idler shaft. Ensure notched end of shaft is facing countershaft as shown.
Fig. 55 Supporting countershaft with wood block
8.
Lift countershaft upward and position wood block between front of shaft and case.
Fig. 56 Installing countershaft rear bearing
9.
Install rear bearing cone on countershaft with Installer Tool No. C-4040 or 6446 or equivalents.
10.
Remove wood block from under countershaft, then lower countershaft front bearing into front bearing cup.