D 350 Pickup L6-359 5.9L DSL (1989)
Check the end of the bearing for evidence that the lubrication has leaked between fan mounting hub and bearing housing.
FAN HUB - DISASSEMBLY
Secure the fan hub and remove the center capscrew and washer.
Support the bearing housing with a bearing splitter between the bearing and the fan mounting hub. Push the shaft out with a 1 3/8 inch diameter push pin.
NOTE: Approximately 6 tons of pressure is required.
Support the bearing housing and push the bearing out using a tool of suitable diameter to press on the outer race of the bearing. A 4-inch section of black
