dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Rollover Valve Vent - Fuel Leakage|Page 1827 > < Air Intake Heater Relay <--> [Intake Air Heater Relay]|Locations
Page 1
background image

Rollover/Pressure Relief Valve: Customer Interest
Rollover Valve Vent - Fuel Leakage

NO.: 14-15-93 

GROUP: Fuel

DATE: Sep. 24, 1993

SUBJECT:
Fuel Leakage From the Roll Over Valve Vent

NOTE:
THIS BULLETIN APPLIES TO VEHICLES EQUIPPED WITH A DIESEL ENGINE.

MODELS:

1989-1993 (AD) Ram Pickup/Ram Cab Chassis

SYMPTOM/CONDITION:

Repeated attempts to force fuel into the tank after the automatic shut off has engaged may lead to a condition where the fuel level in the tank is above the
designed operating level. Fuel may leak out the roll over valve vent in this situation.

DIAGNOSIS:

Inspect the vehicle for signs of a leak in the roll over valve area. If the condition exists, perform the repair procedure.

PARTS REQUIRED:

AR

43" section of 3/16" ID fuel hose

4443177

REPAIR PROCEDURE:

This bulletin involves raising the roll over vent location by installing a section of fuel hose to the roll over valve vent nipple and routing the hose along
the filler tube.

1.

Cut a 43" section of the fuel hose listed above.

2.

Install one end of the hose to the roll over valve vent nipple as shown in Figure 1.

Rollover Valve Vent - Fuel Leakage|Page 1827 > < Air Intake Heater Relay <--> [Intake Air Heater Relay]|Locations