D 350 Pickup V8-360 5.9L VIN 5 (1992)
Valve Body
12.
Push the manual lever shaft and solenoid case connector out of the transmission case. Lower the valve body, rotate it away from the case, pull the
park rod out of the sprag and remove the valve body.
INSTALLATION
1.
Verify that the neutral safety switch has not been installed. The valve body cannot be installed with the switch in place.
Valve Body
2.
Check the condition of the seals on the valve body solenoid case connector, and replace if they are cut or worn.
3.
Check the condition of the manual lever shaft seal. Remove the seal if the lip is cut, or worn. Do not install a new seal at this time.
