D 350 Pickup V8-360 5.9L VIN I (1985)
4.
Remove choke cover and discard.
5.
Drive out remainder of rivets from choke housing, using a suitable punch and small hammer.
6.
Install the supplied choke cover and coil assembly in the choke housing. Make sure that the coil tang engages the inside coil pick-up lever and that
the index notch is aligned.
FIGURE 2
7.
Reinstall choke cover retainers and rivets using a suitable blind rivet tool (Figure 2).
8.
If applicable, eliminate choke control switch on vehicles as follows:
Remove electrical leads from choke control switch. Install the supplied choke control switch jumper, PN 4362459, to the electrical leads removed
from the choke control switch.
FIGURE 3
9.
Install Authorized Modification Label, PN 4275086 (Figure 3).
POLICY:
Reimbursable within the provisions of the warranty
TIME ALLOWANCE:
Refer to the Labor Operation Time Schedule for Labor Operation Number and Time Allowance