Dakota 2WD L4-153 2.5L VIN K FI (1989)
silicone grease if necessary.
CALIPER ASSEMBLY
1. Lubricate slide pin boots and bushings with GE, or Dow silicone grease. Then install boots and bushings in caliper.
2. Coat caliper piston bore, piston and new piston seal with fresh brake fluid.
Fig 19 Installing Caliper Piston Seal
3. Install new piston seal in caliper bore. Press F seal into groove with finger. Lubricate seal and caliper bore with additional, fresh brake fluid after
seal installation.
4. Apply light coat of GE 661, Dow 111 or similar silicone grease to edge and groove of caliper piston and edge of dust boot.
Sliding Boot Onto Piston
5. Install new dust boot on caliper piston as follow:
a. Slide boot over piston until boot lip seats in piston groove.
Snapping Boot Folds Into Place
