Dakota 2WD L4-2.5L VIN P (2001)
Cruise Control Servo Cable: Service and Repair
REMOVAL
1. Disconnect negative battery cable at battery.
Cable Connection at Throttle Body
2. Using finger pressure only, remove speed control cable connector at throttle body bellcrank by pushing connector off the bellcrank pin. DO NOT
try to pull connector off perpendicular to the bellcrank pin. Connector Will be broken.
3. Remove cable from cable guide at top of valve cover.
4. Squeeze 2 tabs on sides of speed control cable at throttle body mounting bracket (locking plate) and push out of bracket.
5. Remove servo cable from servo. Refer to Speed Control Servo Removal/installation.
INSTALLATION
1. Install end of cable to speed control servo. Refer to Speed Control Servo Removal and Installation.
2. Install cable into throttle body mounting bracket (snaps in).
3. Install speed control cable connector at throttle body bellcrank pin (snaps on).
4. Install cable to cable guide at top of valve cover.
5. Connect negative battery cable at battery.
6. Before starting engine, operate accelerator pedal to check for any binding.
